|
 Building Help --> BIG BALL FACTORY
Every once in a while, your red and yellow Balls may fly off the ramp
instead of completing the loop. All you need to do is slightly shift the
ramp section in towards the Big Ball Factory. It will not look like much
of a movement, however, it may make a significant difference in controlling
the Balls on the ramp.
The Ball pick-ups hooked to the Chain require one empty Chain Link in
between the light gray Connector and the orange Connector. Without the one
empty Chain Link, the Ball pick-up will not be able to carry the Balls to
the top of the model.
To keep your Chain from coming apart as it rounds the red Gears, pay close
attention to the picture on the right side of page 19 in the instructions. When
the Chain runs along the outside of the Factory, hooks on each Chain Link should
be pointed toward the floor with the open side of the hook pointing out, away
from the Big Ball Factory.
If you notice that your Big Ball Factory Chain, built with 126 links, becomes too
long (as it may over time), you can substitute one Gold Splicer ("T" shaped clip) for a Chain Link. Remember, gold Splicers are equal to 1/2 of a chain
link. This will prevent your chain from dragging.
Need more help?
Browse the Help Center here on this web site, and if you don't find the information you need, send us your comment or question online, or call us at 1-800-KID-KNEX.
|
