|
 Building Help --> Pirate Ship Park
Video Building Tips:
General Building Tips:
Page 22 - The blue Rods fit through the holes along the bottom of the ship. Do not put them in the holes near the seats.
Page 25, step 45 - The yellow Rod and Connectors that hold the "Pirate Ship Park" sign in place and are shown faded out sticking straight up to the right of the red Connector in the center of page 25 is not actually installed until Page 27, step 52.
Page 26, step 47 - Be sure to install the black Sound Module exactly as indicated and with the activation button facing in toward the center of the ride. When your Pirate Ship makes a complete loop the triangular shaped portion of the orange Cam will hit the black button on the Sound Module activating the sound.
Page 27 - The black strip on the bottom of the ship should be resting on the wheel of the motor. You may need to adjust the number of spacers on the black Rods holding the motor in place through trial and error until you get the black strip and spinning wheel in the right position for your model to complete the full loop. Refer to page 9 or the slip-sheet included in your set and attached here. Be sure your model is turned off while you make this adjustment.  Page 9
Page 27, steps 54-56 - Be sure the figures are firmly snapped into the seats. The seated legs of the figure will snap into each seat. You may want to snap the figures into the seats before attaching the seats to the ship.
Need more help?
Browse the Help Center here on this web site, and if you don't find the information you need, send us your comment or question online, or call us at 1-800-KID-KNEX.
|
